Universal

Specialized for

BGA

See Elnec products at exhibitions:

International IC-China Conference & Exhibition

March 15-16 2010,
Shanghai Mart, Shanghai, China
booth no.: 8A31
exhibitor:PROSYSTEMS

MAGYARREGULA 2010

March 23-26 2010,
SYMA Events Hall, Budapest, Hungary
booth no.: E403
exhibitor: SOS Electronic Kft.

AUTOMATICON 2010
Automatyka Pomiary Elektronika

March 23-26 2010,
Warsaw International Expocentre, Poland
Hall 4, booth no.: L12
exhibitor: W.G. ELECTRONICS

Scandinavian Electronic Event

April 13-15 2010,
Stockholm International Fairs, Sweden
booth no.: C15:68
exhibitor: InstrumentCenter

EXPO Electronica

April 20-22 2010,
Complex Crocus Expo, Moscow, Russia
Hall 1 & 3
booth no.: N/A
exhibitor: Terraelectronica

HOME » Products » Device Programmers » Socket Converters » DIL48/QFP80 ZIF-CS UOC-FU

DIL48/QFP80 ZIF-CS UOC-FU

DIL48/QFP80 ZIF-CS UOC-FU
(ord.no. 70-0852)

See: Converter manual | Accepted package(s) | Useable for programmer(s)

WARNING: DIL48/QFP80 ZIF-CS UOC-FU [70-0852] is discontinued product! Please go to discontinued products section to find the replacement.

  • special converter, assigned for Philips UOC family in QFP80 package
  • operation (mechanical) life of ZIF socket - 10.000 actuations
  • made in Slovakia
Ord. no 70-0852
Socket ZIF QFP80, ClamShell type
Bottom 2 rows, 2x 24 pins, square, 0.6x0.6mm, rows spacing 600mil
Class Specialized for
Subclass UOC
Converter manual
  • Insert converter to the device programmer ZIF socket according to the picture placed near of it. If you have some doubts about orientation of this converter in device programmer ZIF socket, it is valid general rule, the orientation of the text of title is the same as the text on the top of the device programmer.
  • Open the converter ClamShell ZIF socket. Insert the device into it (place device on contacts). The right position of the programmed device in converter ZIF socket is show at picture near (mainly left above) the converter ZIF socket. On this picture reference corner (e.g. position of pin 1) of device is indicated by dot, by number 1, by bezel or by any combination of them.
  • Visually check interconnection between device and converter ClamShell ZIF socket. If everything looks OK, close it and now, device is ready for programming.
  • Be careful, because the incorrect insertion of converter to the device programmer ZIF socket or device to the converter ClamShell ZIF socket can damage the programmed device.
  • To take out the device, open converter ClamShell ZIF socket and remove device from it.
  • When you finish work with converter, remove it from the device programmer ZIF socket.
  • Do not directly touch the pins of the converter and converter ZIF socket, because dirt may cause errors during programming of device.
  • For handling with the device we recommended to use a vacuum pick up tool.

Software note
  • If software version, you're using currently, doesn't contain support for this programming adapter, please download the latest version of software - Regular or OnDemand - from our web site.
 
Accepted package(s)
QFP80 Package
Design